CAS O-Ring Size?

For all your twin cam conversion questions and hints
User avatar
thrash
Austarion Occupant
Posts: 3088
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

CAS O-Ring Size?

Postby thrash » Tue Feb 12, 2013 1:13 pm

Hi Everyone, Does anyone know what the cam angle sensor o-ring size is?

Part number is either MD611831 or MD619648 (superseded part number)

On a separate note, have people just used RTV for the water pipe at the back of the head? There seems to be a gasket part number MD145038, but I'm wondering if most people just use RTV instead of these ultra hard to find parts

mizuno man
Dorifto!
Posts: 55
Joined: Mon May 03, 2010 1:49 pm
Location: Brisbane

Postby mizuno man » Fri Feb 15, 2013 5:48 pm

Cut mine out of gasket paper

User avatar
thrash
Austarion Occupant
Posts: 3088
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Postby thrash » Fri Feb 15, 2013 7:57 pm

thanks for being the only one to respond lol :beer

User avatar
iXNAY
nearly postwhore
Posts: 1415
Joined: Sun Jan 30, 2005 2:30 pm
Location: Bathurst

Postby iXNAY » Fri Feb 15, 2013 10:17 pm

mizuno man wrote:Cut mine out of gasket paper


how do you cut an o-ring out of gasket paper?

and also that didnt answer the question of what size the o-ring was either...?
SR20 powered starion what have I done..... :P

User avatar
Alspos
Flucking kwankers
Posts: 4305
Joined: Thu Jan 08, 2004 2:09 pm
Location: Melbourne
Contact:

Postby Alspos » Sat Feb 16, 2013 8:46 am

Re the o-ring, measure the diameter of the groove, the width and the outside diameter of the shaft. Go to a bearing place or industrial supply place and get the size required. May even cost a dollar to buy a couple of them.

User avatar
thrash
Austarion Occupant
Posts: 3088
Joined: Mon Apr 02, 2007 10:09 pm
Location: Sydney, Australia

Postby thrash » Sat Feb 16, 2013 12:06 pm

thanks guys, www.18u sorted me out :beer


Return to “Twin Cam Land”

Who is online

Users browsing this forum: No registered users and 1 guest

cron