redzone wrote:You removed the balance shafts?
GSRVR wrote:redzone wrote:You removed the balance shafts?
Yeah, I was getting a very audible tin can rattling/knocking coming from the lower balance shaft area that had gotten louder over time. Despit the guides/chains still being acceptable out the shafts came, paranoid that the bearing was on its way out (which did show decent wear & tear compared to the upper shaft) After the BSE the noise hasn't returned. Peace of mind now.
Worth a mention as I'm sure combined with the custom mount I would have been getting slightly more vibration compared to someone still with balance shafts.
redzone wrote:Ah ok. Hopefully then if you ever do a full rebuild you could fit new lower balance shaft bearings to the block if it hasn't gotten too bad
Users browsing this forum: No registered users and 1 guest